How to make the dado (housing) joint by hand

How to make the dado (housing) joint by hand
Dayne Dayne (57)
Total time: 15 minutes 

The dado (or housing joint as its called in the UK) is a dead simple joint used for many things. This guide will take you through making the dado joint completely by hand.

Posted in these interests:

18 guides
Mark the depth

Use a marking gauge or very carefully using any other measuring device.

Make a "knife wall" with a chisel

Using a wide bench chisel, place the bevel side towards the waste and hit lightly on a perpendicular plane to your workpiece. This makes a definitive guide for your saw and cuts the surface wood across the grain to avoid splintering.

Using a cross cut saw, cut down the shoulder lines being careful not to go too deep.

Work your way across the waste

Using the same perpendicular strategy, work your way across the entire waste portion of the dado.

Pare out the waste

Using a stabbing motion with the bevel up, pare out the waste in the joint.

Repeat steps 5 and 6 until you are close to your depth

Diagonal chops with your bench chisel can help to relieve some of the pressure in the waste but be careful not to fracture the shoulder lines of your dado with the shaft of your chisel.

Use a router for final cleanup

If you have a router plane, now's the time to use it. Otherwise, the poor man's router will do. If you're not familiar, check out our guide on how to create the poor man's router.

Dayne's profile pictureDayne
Joined in 2015
Software engineer, co-founder of Howchoo, and renaissance man. Lifelong amateur woodworker, espresso mechanic, freestyle lyricist, drummer, artist, runner, coffee roaster, electrical engineer, gamer, inventor, churner, psychoanalyst, photographer, pizza chef, pit master, audiophile, guitarist, entrepreneur, dad, yogi, cyclist, and barista.
Related to this guide:
Danish oil wood finish on walnut
Danish oil is a general purpose natural finish for wood. It adds depth and richness to any wood species and protects and seals at the same time.
Dayne's profile picture DayneView
In these interests: woodworking
Paul Sellers Mallet
I recently received a copy of Paul Sellers' book on hand tools. In it, he describes the mallet he designed and gives some tips on reproducing it.
Dayne's profile picture DayneView
In these interests: woodworking
My DIY walnut plant stand!
Why put your plant on the ground like some sort of animal when you can spend hours making a wooden plant stand?
Dayne's profile picture DayneView
In these interests: diywoodworking
People also read:
A gift for my mother in law, a simple coat rack made from old walnut.
I built a walking cane for my grandfather from some scrap walnut. I love using hand tools so I stuck to that for the whole project.
I built a cedar stool for my 2 year old nephew for Christmas. I only used hand tools so it took a long time but I learned a lot in the process.
This table lives outside next to a hot tub. I used cedar because it lives at a cabin in Tennessee that already has a bunch of outdoor cedar.
We needed a new dinner table. I wanted to learn about woodworking. This table was built using mostly hand tools and as much traditional joinery as I could figure out.
It can be tricky to cut a mortise without the help of machines but using this method, I find I end up with mortises as clean or cleaner than what I could get with a drill.
This bookcase was inspired by the Ikea bookcase system called Ivar. It was heavily modified (and slightly over engineered). I will take you through my process and hopefully you'll learn something!
Posted in these interests:
"He who works with his hands is a laborer. He who works with his hands and his head is a craftsman. He who works with his hands and his head and his heart is an artist." - Francis of Assisi
Discuss this guide: