Raspberry Pi Static IP Address

How to Configure a Static IP Address on the Raspberry Pi

Making things a little less dynamic.
Ash Ash (193)
Total time: 5 minutes 

The network capabilities on the Raspberry Pi make it possible to create some really fun projects. Once in a while, you'll come across a project that could benefit from a static IP address. If you're using your Raspberry Pi for storage as a NAS device, an FTP server—or any other kind of server for that matter—a static IP address can be a big help.

Here's everything you'll need to complete this guide:

Raspberry Pi 3 B+Raspberry Pi 3 B+×1
Update Raspbian

This guide should work with any Raspberry Pi using the Raspbian OS. Make sure your copy of Raspbian is up to date. If you're not sure where to begin, visit our guide on how to update Raspbian.

Raspbian Find Router IP

We'll need both your router IP address and name server IP. We can find this information by running a few commands in a terminal on the Pi. Remote into the Pi using SSH or open a terminal window from within Raspbian.

To find your router IP address, enter the following command:

ip r | grep default

The router IP address will appear after the text "default via"—take note of it. The name server can be found in the resolv.conf file. Open it using the following command.

sudo nano /etc/resolv.conf

Take note of the name server IP address and close the file with CTRL + X.

Edit DHCPDC Raspbian

The static IP is set by adding it to a file on the Raspberry Pi. In the terminal window, run the following command to edit the dhcpcd.conf file.

sudo nano /etc/dhcpcd.conf
Raspbian Static IP

This document has a few lines of code that can be activated by removing the # to the left of each line. Use the following ledger to properly set your static IP address.

  • Network = If you're using a wired connection, set this to eth0. If you're using a wireless connection, set this to wlan0.
  • Static_IP = This is the static IP address you want to assign to the Raspberry Pi.
  • Router_IP = This is the IP address for the router.
  • Name_Server = This is the name server address. You can use another DNS IP here if you'd like.

Enter your information into the file, be sure to remove the <> brackets. Check the screenshot for an example.

interface <Network>
static ip_address=<Static_IP>/24
static routers=<Router_IP>
static domain_name_servers=<Name_Server>

When that's completed, save the file using CTRL + X.

When the changes have been made, restart the Raspberry Pi. Now is a good time to test your project and make sure the IP address isn't changing. Disconnect and reconnect your Pi from the network. If the IP address changes, verify the information in the previous step saved properly. If it stays the same, congratulations! You've set a static IP on the Raspberry Pi.